.jpg)
Installing a RainSoft EC4 water softener system in your home or business can seem like a daunting task, but with the right knowledge and preparation, it can be a smooth and straightforward process. In this article, we will guide you step-by-step through the installation process, so you can enjoy the benefits of soft water in no time.
Locate the main water line and shut off the water supply: The first step in installing your RainSoft EC4 water softener system is to locate the main water line that supplies water to your home or business. This is typically located in the basement, utility room, or garage. Once you have located the main water line, shut off the water supply to your home or business to prevent any leaks or damage during the installation process.
Install the water softener unit in a location with proper drainage and near a power outlet: Next, choose a location for your RainSoft EC4 water softener unit that has proper drainage and is near a power outlet. This will ensure that the unit can function properly and will not be damaged by water or lack of power. It's also recommended to keep the unit in a location that is easily accessible for maintenance and monitoring.
Connect the supplied inlet and outlet pipes to the main water line: Once the unit is in place, you will need to connect the supplied inlet and outlet pipes to the main water line. This can be done using the fittings provided with your RainSoft EC4 water softener unit. It's important to use the correct fittings and to double-check for any leaks before moving on to the next step.
Connect the supplied drain line to a nearby drain or sump pump: The RainSoft EC4 water softener unit also includes a drain line that must be connected to a nearby drain or sump pump. This is necessary for the unit to properly discharge the water used during the regeneration process. It's important to ensure that the drain line is connected securely and that there are no leaks before moving on to the next step.
Plug the unit into the power outlet and turn the water supply back on: After all the pipes and drain lines are connected, plug the unit into the power outlet, and turn the water supply back on. This will power up the unit and allow it to start working.
Set the time and date on the electronic control panel: The RainSoft EC4 water softener unit features an advanced electronic control panel that allows you to easily program and monitor the unit. The first thing you will need to do is set the time and date on the control panel, so the unit can properly function.
Run the unit through a regeneration cycle by pressing the "Regenerate" button on the control panel: After the time and date have been set, the unit will need to go through a regeneration cycle. This is necessary to regenerate the resin bed and remove any accumulated minerals. To start the regeneration cycle, simply press the "Regenerate" button on the control panel.
Test the water hardness level and adjust the unit's settings as necessary: Finally, test the water hardness level and adjust the unit's settings as necessary. If you find that the water is still too hard, you may need to adjust the unit's settings or contact RainSoft for further assistance.
In conclusion, installing a RainSoft EC4 water softener system is a relatively simple process that can be completed in a few hours with the right tools and knowledge. By following the steps outlined in this article, you can enjoy the many benefits of soft water in your home or business.